removing load manual feeder option dell b2360dn printer

Then, with the second 'pause', it pops up another couple of degrees into the fully deployed position. With the first 'paper pause' I described in my original post, the flag pops up another couple of degrees. I can hear a quiet 'click' as the flag contacts something hard (this is distinct from the much louder 'pop' that accompanies the pause in the paper movement). Once the sheet feeds into the scanner past the flag, the flag pops up most of the way to the fully deployed position. When the page starts to feed and moves upwards into the slot, the flag follows, and I can see it pushing up against the bottom of the page. When I put a page into the feeder, the page pushes the sensor flag down and there is a beep, just as you describe. Interesting behavior, though, when I run a sheet through the machine and keep an eye on the sensor flag: The Sensor flag is deployed, and seems to move freely, both up and down. Dry with a lint free rag (an old clean tee-shirt works good) or compressed DRY air. Next, using warm water and a mild soap solution (never alcohol), wash the grime from the rubber tire surfaces then completely dry the feed roller and plastics. lift small clip enough to slide the roller completely off the end of the shaft) Have someone hold the unit up at an angle while you remove the Feed roller. Is it there? Is it twisted or damaged?Īlso, the cleaning the rollers 'trick' applies to your feed problem as well. Along the top edge of the pad, there should be a metal strip. If you pull out your tray and look down at the rubber pad, this is called the Separator Pad. We won't really know until he replies to the thread he started. so my interpretation is that the ADF feeder is what he's having a problem with. You can't scan or fax using the main paper tray. To quote ' It doesn't matter if I'm scanning or faxing, it will jam at some point.'

Removing load manual feeder option dell b2360dn printer